Vendor Specific SMART Attributes with Thresholds: SMART Attributes Data Structure revision number: 16 Note: The 97% CPU usage on single CPU is caused by screen recorder itself.Smartctl 6.5 r4214 (local build)Ĭopyright (C) 2002-16, Bruce Allen, Christian Franke, = START OF READ SMART DATA SECTION = I like to keep my Conky running on the right 20% of my primary monitor: Many people like to show their system status (and health) on a portion of their desktop. Of course it will be obsolete well before then. At this rate the NVMe SSD lifespan will be 300 years. The Percentage used hit 1% on October 2020. The drive was purchased in October 2017 and it was still 0% in December 2018. This isn't disk usage percent but life used percent. The most important field is Percentage used which shows as 0%. Smart Log for NVME device:nvme0 namespace-id:ffffffff Next gather information available from SSD: $ sudo nvme smart-log /dev/nvme0
To install it use: sudo apt install nvme-cli
Your SMART utility already measures SSD life but not for NVMe SSDs. If you have an SSD they're life span is measured in trillions of writes. If the RAM checker finds a bad memory block you can blacklist it using these instructions: Is there a way of limiting the Kernel's memory manager to use only 75% of memory? NVMe PCIe M.2 Gen 3.0 x 4 (or 2) SSD
If your machine locks up and display a bad memory error you can test your RAM following these instructions: How to check for errors in RAM via linux?. It could also mean your CPU heat sink needs to be reseated with new thermal paste. It could also mean CPU / motherboard needs a dust cleaning with compressed air (don't use your breath which contains moisture). On a laptop means fan exhaust vents are clogged or RPM is too low. CPUĪnother potential indicator of a degrading fan is CPU heat level. Fansįans have impending failure indicators but that is based on your hearing and listening for indicators such as oscillating speeds, squealing bearings, etc. Mechanical devices such as hard drives do have indicators of impending failure as per SMART reporting which you already know about. Electronics generally work 100% or zero percent.